van - 22-12-2009 at 04:55 PM
I just bought a Scrub Rush ATB from Hellermd. One of the wheel was damage in shipping. I've been looking all over the web for replacement part but
couldn't find anything for the Scrub brand. This is my first ATB so I don't know what other wheels are compatible with my board. I just need to know
if anyone has a spare I can buy or if it's compatible with GI or MBS. Thanks and merry christmas!!
Edit: The Scrub Rush has 12mm hollow shafts if that helps. Wheel is a 5 spoke , two piece with 200x50 tires.
indigo_wolf - 22-12-2009 at 05:22 PM
The GI MAK tires are 200mm x 50mm.
I wanna say the Vegas hubs are 110mm. I will break out the calipers when I get home, unless someone else posts first.
The GI Trucks use 12mm bearings except for the Skate Titanium which uses 9.5mm bearings.
Angus, Dino , and Corey all carry Scrub boards and should be able to order the hub if it comes down to it. Sorry if I missed any PKF supporting retailers.
ATB,
Sam
Houston AirHead - 22-12-2009 at 05:24 PM
i bet you could still ride that wheel van. just use about 5 less psi as the other wheels
acampbell - 22-12-2009 at 05:54 PM
I have one. Call me 800-592-1195 or angus AT coastal windsports.com
van - 22-12-2009 at 08:59 PM
I'm not sure what PSI I pumped it up to but the tire started to bulge out a little so I stopped. I didn't want to risk messing up a good tire. Oh..
typo above .. my tires are 200x50 , not 220x50. I'll give Angus a call in the morning.
Thanks for the help.
van - 24-12-2009 at 06:19 PM
Angus,
Good talking to ya. I measure my bearings are they are 20mm on the inside and 28mm on the outside so the wheel have 28mm seats. If you can find a 5
spoke wheel that match that requirements, let me know.