Wasd9595 - 7-6-2011 at 05:05 AM
Hi :D
Today i received my first kite. Is is an Ozone Flow 3m kite with handles. But when i look at all these parts (Handles, Lines and kite) I really dont
know how to assemble these parts. I have been searching the web but i can only find vids with people, who are setting a kite up witch is assembled.
Can anybody help me? :D
Thanks
-Wasd
PHREERIDER - 7-6-2011 at 05:13 AM
hi this is anybody, you rang.
just connect the knots ..or is that dots.
lay it out. ID front, ID top
ID bridle knots on front
ID bridle knots on the rear
lay out handles ID front lines , ID rear lines
connect the knots with larks head loops.
hold handles ...add wind
Todd - 7-6-2011 at 05:13 AM
Welcome to the forum! Go visit Angus very good info here First time with a four line kite
Wasd9595 - 7-6-2011 at 05:27 AM
@Todd Thanks, I think i will read that guide. It looks really awesome! :D
kiteboyza - 7-6-2011 at 06:00 AM
what no instructions, Blademoaner will be really upset....lol
indigo_wolf - 7-6-2011 at 06:27 AM
Since it has been mentioned, Ozone tried to make setup for the Flow 3M a tad easier.
At the loops at the ends of the flying (power & brake) lines there are little numbered tabs.
#1 goes from the left hand power leader on the left hand control handle to the left hand power bridle leader.
#2 goes from the left hand brake leader on the left hand control handle to the left hand brake bridle leader.
#3 goes from the right hand brake leader on the right hand control handle to the right hand brake bridle leader.
#4 goes from the right hand power leader on the right hand control handle to the left hand power bridle leader.
See that attached picture for details (this diagram should also be on page 12 of your manual).
ATB,
Sam
macboy - 7-6-2011 at 01:05 PM
Everybody forgot to mention step one: Smile from ear to ear!