NPWfever - 26-4-2008 at 09:04 PM
Designs for the light wind plyboard, and whatever name I decide will go on the bottom.
A: 
B: 
C: 
Any name ideas welcome
tridude - 27-4-2008 at 05:43 AM
whats the dimensions? maybe a bit less taper from the rails to tips (wider tips). Remember to keep it flat and fat!
NPWfever - 27-4-2008 at 09:06 AM
Here are the dimentions, and as far as the taper I matched them as closely to the board as possible. It might be a little harsher but I think it
should still work.
tridude - 27-4-2008 at 10:11 AM
Id go 2 inches wider, with only a half to 3/4 inch taper in on the tips, starting no more than 3 inches up the rail. The way you have your dimensions
in this pic, your fins are going to be ineffective. Take a look at my mini door pic and fin positioning. I remeasured and its 5 feet by
20"........................
Dont be put off by wider tips, most of it will be out of the water once youve planned and begin edging. Like I told you on the phone, all that laughed
my first time out have used, and liked it!
NPWfever - 27-4-2008 at 10:20 AM
I'm not discouraged by wider tips, I know it is the way to go, and give you more pop. I just figured those tips were the best out of all my attempts.
It may look really drastic, but that first angle is only over 2 inches and that last angle is only over 2 inches. For each corner I am really only
losing a square foot, on a 960 square inch board. This leaves me with an effective 916 square inches or 76 square feet......wait, thats way too big,
what did I do??? :ticking: