Hello!

Ive had trouble with my beamer (3.6 Meters) the brake lines were loads shorter then the power lines so after making new knots in my handles I Went out for a test flight today, all was good except it didnt seem to be generating enough power.. Also i think the brake lines may still be tiny bit shorter then the powerl lines,Also there was no slack in the brake lines, how can i add some slack?

Many thanks i look forawrd to see the advice

Wind was at 15mph

Put in an an extension on your brake leader.
S

POWER LINES A FOOT LONGER THEN BRAKE LINES!

All should be equal.

Are the lines sleeved ? If so and they aren't sewn shorten the power lines.

If they are sewn sleeves then add an extension to the brakes like Scudley said.

es they are sleeved, I Measured the point at which the length is longer, shall i move the sleeve down to this point so they are exact, or should i move it 1cm even further for brake line slack?

did you try stretching your brake lines? This is more than likely why your power lines are that much longer to begin with. The powers are under alot more tension and will stretch more than your brakes.

Yes,

I Stretched them good and proper, still loads longer :D

You need three feet of of the thinnest (1/8 or 3/16) yacht braid from your local boat supply shop. Cut the 3' line in half. Tie equal loops at one end of each piece. Tie knots at the other ends making sure the knots are the same distance from the loops. Larks head the the extensions to the brake leaders. Larks head your brake lines to the extensions.
S

No..
It has a sleeve so i just untied the knots and pulled the sleeve down retied the knots and ka blam! done it :P

So where are you going on your expedition since you got your lines sorted?

Hopefully catch a nice gust, and land in the middle of south africa during peak season