Power Kite Forum
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Stalling in the power zone?????
shaggs2riches
Posting Freak
*****


Avatar


Posts: 1774
Registered: 4-10-2009
Location: Lloydminster, Saskatchewan, Canada
Member Is Offline

Mood: low winds here I come

question.gif posted on 21-11-2009 at 09:41 PM
Stalling in the power zone?????


I finally managed to get some scudding in today. It took some rather strong winds (45-55). I noticed however that I only got in a scud of about 5 feet. Maybe I was doing something wrong though. I flew the kite over to the edge of the window, turned it back low into the power zone, and when it was fully powered I dug my heels in and the kite pulled me along. Once the kite flew to the other side, the scud was over.

Which brings me to the topic of this thread. With my three line ozone imp trainer, is it possible to stall the kite in the power zone so that I get a longer scud? So far the only thing I have managed to do is fly it fast through the zone, taking it either to the other edge or up to zenith. As usual any advice is appreciated.

Shaggs



what I fly/ride:
19m Flysurfer Speed 2 SA
12m Flysurfer Speed2
6m Ozone access xt
1.5m Ozone imp trainer
144cm Airush Switch
152cm lib tech skate banana
MBS Pro 90
Jereme Leafe Pro 95
View user's profile
furbowski
Posting Freak
*****


Avatar


Posts: 1470
Registered: 1-5-2008
Location: hong kong
Member Is Offline

Mood: stuck on a small island with big trees and tiny beaches...

[*] posted on 21-11-2009 at 09:46 PM


keep it in the zone by looping it or flying it in a figure 8. You'll be able to scud until your arms drop off or you run out of room!

you actually don't want to stall it in the power zone, you want to keep it flying in fast loops or fig 8s.



fixed bridles, flying static, been two years now... ??? folks must be wondering....

sting 1.7, dp power 2.5, crossfire 3.2, ace 5, blade iv 6.5, ace 8, ace 12...

also a couple of arcs, 12 syn and 12 phanny, but i\'m not yet up to speed on them.

(13.11.09)
View user's profile
power
Posting Freak
*****


Avatar


Posts: 1023
Registered: 12-7-2009
Member Is Offline

Mood: Arcy

[*] posted on 21-11-2009 at 09:47 PM


In order to keep a scud going, you will have to figure 8 the kite through the power zone. If you stall the kite in the power zone, it will begin to lose power, or suddenly power up on you if you release the brakes.



-08 Best Nemesis HP 14m
-07 North Rhino 10m
-05 Best Nemesis 10m
-04 Slingshot Fuel 13m
-05 Flexi Storm 8m, 10m, 12m, 14m (FOR SALE!!)
-05 Naish 5.5m (FOR SALE!!)
View user's profile
power
Posting Freak
*****


Avatar


Posts: 1023
Registered: 12-7-2009
Member Is Offline

Mood: Arcy

[*] posted on 21-11-2009 at 09:47 PM


Sorry furb, we must have posted at the same time:bigok:



-08 Best Nemesis HP 14m
-07 North Rhino 10m
-05 Best Nemesis 10m
-04 Slingshot Fuel 13m
-05 Flexi Storm 8m, 10m, 12m, 14m (FOR SALE!!)
-05 Naish 5.5m (FOR SALE!!)
View user's profile
Bladerunner
Posting Freak
*****


Avatar


Posts: 9679
Registered: 17-10-2006
Location: Vancouver
Member Is Offline


[*] posted on 22-11-2009 at 09:32 AM


You might try tweeking the front lines to speed it up again ?



Kites: 2.5m Profoil , Quadrifoil XL kitesurfer, NPW 5 Danger.
Flexifoil: 1.7m Sting, 4.9m Blade 3, 9m Blade 2.
Flysurfer : 19m Speed 2 SA, 7m Pulse
Peter Lynn :18m Phantom, 15m Synergy, 10m Synergy, 1200 Farc, 460 Sarc, 130 Tarc, 5m Peel, 4.2m , 6.4, 8.5 C-Quads, 3.5 LS2 single skin.

Rides: Flexi / P.L. Frankin'Buggy , Shaped + straight skiis, sand skis, Coyote blades. Core 95 ATB. RKB R2 ATB .

Ken (K2)
View user's profile
canuck
Senior Member
****




Posts: 514
Registered: 5-10-2006
Location: Calgary, AB
Member Is Offline


[*] posted on 22-11-2009 at 06:15 PM


Turn 2 or 3 full circles in the eye of the power zone then figure 8 up and turn 2 or 3 circles the other direction to untwist your lines. Don't do too many loops or the lines get too tight to control. Might not be a good idea to try it in 45-55 kph winds to start out in case you start windmilling and loose control (been there, done that; waste flying time untangling the mess after).



FB: Pro Foil 5.5m, PL Reactor II 3.5m, Radsail 3m
Depower: GIN Shaman 12m & 6m, Shaman2 9m (incoming), PL Venom II 13m, Venom I 10m


HQ Powerkites seat harness
Salomon snowblade 90, straight & shaped skis
PL Comp ST buggy, MBS Comp 16 Pro, Coyote All Terrain Rollerblades
BodyGlove wakeskis
View user's profile
furbowski
Posting Freak
*****


Avatar


Posts: 1470
Registered: 1-5-2008
Location: hong kong
Member Is Offline

Mood: stuck on a small island with big trees and tiny beaches...

[*] posted on 23-11-2009 at 07:12 AM


Quote:
Originally posted by canuck
Might not be a good idea to try it in 45-55 kph winds to start out in case you start windmilling and loose control (been there, done that; waste flying time untangling the mess after).


:thumbup:

yup, that's exactly right! all part of the learning curve... and the kite can stay semi-powered up like that and take a looong time to come back to ground...

@ power... I think you may have caught my "second thoughts" edit, the second part of the post above.... It's a race sometimes to answer some Q's LOL... No worries at all!



fixed bridles, flying static, been two years now... ??? folks must be wondering....

sting 1.7, dp power 2.5, crossfire 3.2, ace 5, blade iv 6.5, ace 8, ace 12...

also a couple of arcs, 12 syn and 12 phanny, but i\'m not yet up to speed on them.

(13.11.09)
View user's profile
shaggs2riches
Posting Freak
*****


Avatar


Posts: 1774
Registered: 4-10-2009
Location: Lloydminster, Saskatchewan, Canada
Member Is Offline

Mood: low winds here I come

[*] posted on 28-11-2009 at 08:01 PM


thanks for the advice guys! I forgot I posted this thread sorry for the slow response. I will keep these things in mind the next time I get enough wind to try scudding



what I fly/ride:
19m Flysurfer Speed 2 SA
12m Flysurfer Speed2
6m Ozone access xt
1.5m Ozone imp trainer
144cm Airush Switch
152cm lib tech skate banana
MBS Pro 90
Jereme Leafe Pro 95
View user's profile

  Go To Top

Hosted by: Mad Moose Studio