Power Kite Forum
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Safety releases on Neo 2
bribe36
Junior Member
**




Posts: 43
Registered: 9-11-2009
Location: Alberta, Canada
Member Is Offline


[*] posted on 12-9-2010 at 08:14 PM
Safety releases on Neo 2


I was shopping for a new kite on the weekend and I got into a discussion about the safety releases on the Neo 2. I have the 8m and I'm pretty certain it has only the one safety release on the chicken loop. Is this right? Shouldn't there be another safety release between the bar and kite, the true "primary release"?
View user's profile
Maven454
Posting Freak
*****




Posts: 1838
Registered: 2-7-2009
Location: Northern Virginia (DC)
Member Is Offline

Mood: I has a grumpy.

[*] posted on 13-9-2010 at 02:29 AM


No, because the Neo II uses a fifth line safety, it release from the chicken loop to a leash. It does not use the leash-less re-ride safety of the open cell foils (the one between the bar and the kite). The Neo I did not have a fifth line and used the leash-less re-ride safety, but many users complained that it did not depower the kite properly. The chicken loop safety on the Neo II drops it to the fifth line (assuming that you have your leash attached), otherwise it disconnects the kite completely. See page 28 and 30 in the manual.



"I gave up on wind speeds... its either crappy, gravy, epic, or stupid... in that order"
--Drewculous

Ozone: Imp III Quattro 1m and 1.5m, Flow 2m, 3m, 4m, and 5m.
NAPKA# US454
View user's profile
bribe36
Junior Member
**




Posts: 43
Registered: 9-11-2009
Location: Alberta, Canada
Member Is Offline


[*] posted on 13-9-2010 at 08:11 PM


I did look over the manual and sure enough it shows only the one release, same as my kite. However while searching for a 14m Neo II I came across this picture showing both releases.

hq_traction_kite_bar_neo-200x300.jpg - 9kB
View user's profile
bribe36
Junior Member
**




Posts: 43
Registered: 9-11-2009
Location: Alberta, Canada
Member Is Offline


[*] posted on 13-9-2010 at 08:12 PM


Quote:
Originally posted by bribe36
View user's profile

  Go To Top

Hosted by: Mad Moose Studio