Xungust
Junior Member
Posts: 3
Registered: 11-12-2010
Location: Boston, MA
Member Is Offline
|
|
Is it my fault or does the kite need to me adjusted
Just bought an Ozone IMP 3.5. I am having trouble getting the kite to park at 12 o'clock, 10 o'clock, and 3 o'clock. The winds were between 11 and
16 knots or 15 to 25 mph. My problem was the kite kept flying past my mark. By that I mean if you think of the wind table and were I am standing as
being the center line the kite is flying past it, stalling, and cause the kite to get tossed about until it catches its breath. So is it my fault
that the kite is acting in this manor? Any tips are welcome. Do I need to fiddle with the third line (break line)? Again any tips are welcome.
Eric
|
|
BeamerBob
Posting Freak
Posts: 8308
Registered: 11-5-2007
Location: Down on the bayou
Member Is Offline
|
|
Those aren't winds that will allow you to park the kite at the edge and it sit there. You need steady winds for that. The increase in wind speed
causes the kite to surge forward and past the edge of the wind it is able to fly in. Then it luffs and drifts back enough to refill with air. You'll
be more happy with your kite and your ability to fly it when you get to fly in better more consistent winds. Flying in those winds will make you a
better kiter though, because you will better learn to anticipate what the kite is going to do before it does it, even when you are watching others
fly.
Coastal Wind Sports Team Rider
Landsegler Disc wheels
PTW Hero Buggy - XXtreme ApeXX Buggy US 88 - Libre Hardcore
IvanpahBuggyExpo.com
Youtube link
Bob Muse
HQ Montana X 8m, Montana IX 12m, HQ Ignition LEI 5m,
PL Phantom 12m, 15m, Big Blu 24m+, Synergy 10m, Venom 10m, 13m , Phantom II 12m Vapors 3.8, 5.4, Crosskite Sonic 7m, PKD Combat 10.3m
Uturn Butane 2.5m PKD Buster 3m Genetrix Hydra 7m Ozone Yakuza GT 14m
|
|
acampbell
Posting Freak
Posts: 3879
Registered: 26-7-2006
Location: Las Cruces, NM. Sometimes
Member Is Offline
Mood: Digging Deserts and Mts.
|
|
In higher winds like that it can help to tighten the brake tension, too. In the center brake leader, tie another knot a couple of inches or so closer
to the bar, then move the larkshead knot at the end of the brake line up to that knot. Experiment to see what amount of trim works better for you.
Good Luck
|
|
|