Taper123
Senior Member
Posts: 768
Registered: 6-1-2006
Location: Texas
Member Is Offline
Mood: Ready for some sand!
|
|
parts for a board
I started out with an MBS Ambush Warrior... not the greatest, but it was new and in my budget. 6 months later the tires are worn out (read slick...
no tread) and the rubber in one of the trucks is loose and wobbly. Are parts available for this? Or would it be better to save up and get a better
board? I mainly ride in grassy fields, sandy beaches, and onlight wind days... ya can't beat a large parking lot.
|
|
KYTE SLINGER
Member
Posts: 430
Registered: 7-5-2003
Member Is Offline
Mood: freestyle tactician
|
|
Taper123
its not the board, get use to going through lots of tires and other parts .... your just using them up fast on a hard surface, sand eats away the
other rubber parts faster than New York second
I'm surprised they lasted this long, Matt from Ground Ind's brought 100 tires to the NABX event within 2 days they were all gone, as in used up
|
|
Taper123
Senior Member
Posts: 768
Registered: 6-1-2006
Location: Texas
Member Is Offline
Mood: Ready for some sand!
|
|
Quote: | Originally posted by KYTE SLINGER
Taper123
its not the board, get use to going through lots of tires and other parts .... your just using them up fast on a hard surface, sand eats away the
other rubber parts faster than New York second
I'm surprised they lasted this long, Matt from Ground Ind's brought 100 tires to the NABX event within 2 days they were all gone, as in used up
|
Thanks for the info. Now to shop for a good supplier
|
|