I have come across a little used TURBO BAR by OZONE .
It is a Crossover bar for 4 line Fixed Bridle kites. Good for almost all FB kites. It has a spinning bar ,top hat safety release ,Ronstan pulleys,on the fly trim adjusters, reverse launch/landing strap and comes with the Megatron chicken loop on it as well.


$100 shipped to lower 48

Does this bar come with its own line set or do you use your line set that you normally use with handles ? I have been using a PL Reactor 1 4.9 to learn to land board on handles. Wanting to move into depower soon. But thought this may be a little easier to board with. Looks kinda complicated any thoughts?

You use the same lines that you use w/ handles. It's not complicated at all. Powers to the center,brakes to the outside.If you get twists you just spin the bar instead of the kite. If you crash nose down, just pull the strap to reverse launch. Or, use it to land.
In case of emergency, you can pull the bar all the way in(backstalls kite),or pull the tophat QR. And lastly ,there is the QR on the ckicken loop. It is a $200 bar brand new,it has very low miles on it. You will need a harness with this bar! WG

I think I will give it a go. I will take it. PM sent

SOLD

damit!