Want to replace SZ1 & SZ2 on the 21... but can't see a way of doing it other than removing the entire bridle :o any suggestions? For DIY... I could just send it to John again

Assume you are talking about this:
http://www.flysurfer.com/wp-content/uploads/lines/speed3/spe...

Are those segments sewn? Can you post pics?

ATB,
Sam

Yah... they just larks head onto the br3 lines - so it's a daisy-chain of larks head all the way down from the top... looking at that diagram, maybe it won't be as bad as I imagined - I'll only have to undo the Z lines, nothing else.

But if there's a sneaky way to un-larks head a connection... that'd be good to know cos SZ1 joins both BR1 and BR2 which makes it tricky...