Power Kite Forum
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: parts for a board
Taper123
Senior Member
****




Posts: 768
Registered: 6-1-2006
Location: Texas
Member Is Offline

Mood: Ready for some sand!

[*] posted on 15-6-2006 at 06:46 AM
parts for a board


I started out with an MBS Ambush Warrior... not the greatest, but it was new and in my budget. 6 months later the tires are worn out (read slick... no tread) and the rubber in one of the trucks is loose and wobbly. Are parts available for this? Or would it be better to save up and get a better board? I mainly ride in grassy fields, sandy beaches, and onlight wind days... ya can't beat a large parking lot.
View user's profile
KYTE SLINGER
Member
***




Posts: 430
Registered: 7-5-2003
Member Is Offline

Mood: freestyle tactician

[*] posted on 15-6-2006 at 01:50 PM


Taper123

its not the board, get use to going through lots of tires and other parts .... your just using them up fast on a hard surface, sand eats away the other rubber parts faster than New York second
I'm surprised they lasted this long, Matt from Ground Ind's brought 100 tires to the NABX event within 2 days they were all gone, as in used up
View user's profile
Taper123
Senior Member
****




Posts: 768
Registered: 6-1-2006
Location: Texas
Member Is Offline

Mood: Ready for some sand!

[*] posted on 20-6-2006 at 03:40 PM


Quote:
Originally posted by KYTE SLINGER
Taper123

its not the board, get use to going through lots of tires and other parts .... your just using them up fast on a hard surface, sand eats away the other rubber parts faster than New York second
I'm surprised they lasted this long, Matt from Ground Ind's brought 100 tires to the NABX event within 2 days they were all gone, as in used up



Thanks for the info. Now to shop for a good supplier
View user's profile

  Go To Top

Hosted by: Mad Moose Studio