Hello..newbie need help.. please :-)

should the length of power bar lines be the same?!!
from the bar to the point where they are connected to the steering and front 21m ( in my case) lines

SEE picture ,please

https://app.box.com/s/mp6k7vsky1niia4q7j80

thanks for your reply

cheers

The length of your lines should be equal, but the power lines will *always* stretch, and that affects the performance of your kite.

Here is a video from BEST kites about tuning your bar and lines to be equal, and while it's a different brand, it may help you.




http://www.youtube.com/watch?v=J2onytU92v4

And once you've sorted the bar end out, you should check for stretch in your bridle since you have a FS and it has quite the bridle system. Here is a video about performing a "mixer test" on a flysurfer kite to find out if some of your bridle lines need adjusting, and if so, how to do that.




http://www.youtube.com/watch?v=4m1IcYQyVVA


have fun and good flying, a 21m speed 3 is quite the kite to have!

with a brand new lineset the bar leaders should be the same length as the black trimmer leader. once the lineset beds in though you'll most likely notice stretch in the gray lines and shrinking of the red/green lines. now the kite will probably backstall and become annoying, so if you pull in the trimmer till the backstall goes away, now you know how much to shorten the black leader line by loosening the knot and weaving it back thru. shorten the leader, reset the trim strap and fly it again. the amount of backstall is nearly zero on a 'tuned' kite.

hope that makes sense , but measuring the bar like your picture shows isn't really the right approach.

Quote: Originally posted by solamentej

Hello..newbie need help.. please :-) should the length of power bar lines be the same?!! from the bar to the point where they are connected to the steering and front 21m ( in my case) lines SEE picture ,please https://app.box.com/s/mp6k7vsky1niia4q7j80 thanks for your reply cheers

I have measured the main front lines and the steering lines... the main/front lines are about 3 cm longer than my steering ( red/blue lines) 21m vs. 21m+ about 3 cm... I have shorten the black trimmer leader by about 3cm.. versus the bar leaders.. so now overall length of all 4 lines should be the same +/-

just trying to explain my kite line tuning....will test again on the weekend...

thanks for your replies.. appreciate...

I recently acquired a used 15m Speed 3 and I am trying to learn as much as possible about tuning/optimizing. I have watched the Youtube video mentioned above. For the most part it seems clear except that it is unclear about how the kite is layed out when doing the mixer test and measuring lines.

I assume that the kite or lines must be fixed or anchored in a stationary position in order to check/compare the various line lengths. The video on shows the guy pulling on lines.

I am surprised that Flysurfer does not have videos for this on their website. The FS manual that I have seen is a little confusing with the way it has been translated.

Any thoughts or reference to other videos would be appreciated.

cheers