Flysurfer bar cap gone
DenisLaMenace
-
18-8-2009 at 12:53 PM
Yesterday the red cap at the end of my SA2 19m bar popped out like the glue inside melted or I dont know
unlike this bar, mine does not seem to have screws that keeps cap in place:
http://img360.imageshack.us/img360/4301/flysurferbarcg1.jpg
My 19m is probably one of the early ones.
so fortunately I was close to shore and went back to fix it with tie wraps to finish my session.
Tonight I want to put some glue to fix it back, but I wonder what type of glue would fit best: aquaseal, construction ???
any idea !!
I intend to fit some holes with a stainless screw also to make sure it does not happen again
PHREERIDER
-
18-8-2009 at 01:06 PM
waterproof epoxy. if it 's carbon taping want be so easy.
sandblast/micro etch if you can or at least sand the components, may not need to tap
good luck
DenisLaMenace
-
18-8-2009 at 05:50 PM
Quote:
Originally posted by PHREERIDER
waterproof epoxy. if it 's carbon taping want be so easy.
sandblast/micro etch if you can or at least sand the components, may not need to tap
good luck
done ! will see the result tomorrow
thanks for the tip
