mikellli - 27-5-2011 at 01:13 PM
I would like to make plywood kiteboard. Has anyone had any experience with these? I drew the board that my friend will cut on a CNC machine. Rocker of
the board I will make with a mold and steam cleaner. Does anyone know the best thickness of plywood, and coatings that are best for
tamper outside influence. Sorry for bad english, I understand it well but I find it hard when I write a sentence. 
Best regards
macboy - 27-5-2011 at 02:12 PM
This'll give you all you need to know and then some. I built three (just worked out best out of two sheets of plywood so why build only one?)
Plyboards
Kamikuza - 27-5-2011 at 05:33 PM
kiteforum.com has a very active board builders forum ...