A kite buggy friend was out for the first time with his new MG AerobiC buggy today. What a beautiful buggy! Maybe he will tell you about the adventure
of getting it to the states. Click on the picture to enlarge.
BeamerBob - 22-2-2014 at 09:56 PM
Martin commented about sending one to texas. If I understood correctly, this is the first sale to the US. DAKITEZ - 23-2-2014 at 09:17 AM
He needs to extend that front axle out and straighten those legs a bit. His legs are way to bent. He must of had a peter lynn or flexi bug before
He needs to extend that front axle out and straighten those legs a bit. His legs are way to bent. He must of had a peter lynn or flexi bug before
He's in freestyle mode!!kitemaker4 - 23-2-2014 at 02:56 PM
Is the picture taken by the convention center on the flats.
Susan (npw goddess)
That's right!
southpadreburt - 23-2-2014 at 03:52 PM
yes, that is the convention center on South Padre Island. When the wind is low or not from a good direction we often go there to buggy.kitemaker4 - 23-2-2014 at 08:26 PM
Where else do you buggy besides the flats. It has been a few years since I have been on the island.
Susan (npw goddess)KAZEDOKA - 24-2-2014 at 09:51 PM
BRET, congrats nice buggybobsalinas - 25-2-2014 at 06:58 PM
nice buy dude,
you be stylin now and moreover you will be hard pressed to break that bad boy bug.
now Bert needs one too!Yeldarb - 19-3-2014 at 09:45 AM
He needs to extend that front axle out and straighten those legs a bit. His legs are way to bent. He must of had a peter lynn or flexi bug before
Both. After reading your post, I extended the downtube so that my legs were less bent. The result was that my turning radius decreased because I
didn't have enough "slack" in my legs to turn the wheel. In my area I turn a lot and turn hard!Yeldarb - 19-3-2014 at 09:50 AM