leebrianh - 31-7-2007 at 02:26 PM
I have a Libre Full Race Xsmall but side rail is too high, would like to lower them down, making them size small.
Initially, I thought about bringing to local welder but they don't know buggy and I am afraid they might mass up geometry.
Is anybody here a welder as well who can help me out? I live in Delaware. - Brian
SecondWind - 31-7-2007 at 05:50 PM
Brian,
Do you have any custom bicycle frame builders in the area?
Maybe something like this in Philly:
http://www.bilenky.com/Home.html
leebrianh - 31-7-2007 at 08:58 PM
bicycle frame builder, ye? I never thought about it but it makes sense. Thanks. - Brian
SecondWind - 1-8-2007 at 07:44 PM
Brian,
I have had a few customs made for me by different builders and the craftsmanship has been top notch – you just got to love a custom built fillet
brazed frame 
krumly - 2-8-2007 at 07:44 AM
Just remember if you're looking for a bike framebuilder to do work on SS tubing instead of carbon steel or chromoly, they should be somebody who
builds TIG [welded] frames. Stainless needs to be welded, not brazed.
krumly
SecondWind - 2-8-2007 at 09:51 PM
Good point Krumy - however, I think Stainless tubing for bicycles can be brazed with silver not brass for lugged construction.
I would just get it TIGed.