2) Since the rear lines are loose and attached to the far ends of the Peter Lynn Zero4 control bar (40cm), is it really possibly to steer the kite by
pulling on loose rear lines? (sorry but the whole depower system is confusing compared to fixed bridle + handle setup) When I fly fixed bridles, I
pretty much stear the kite by pulling one of the leading edge lines. So for PL Arcs, it seems weird that I would be apply pressure by pulling on one
slack brake lines while the two leading edge lines have the same pressure (since it is attached at the same point - the middle) Pulling on a slack
brake line applies very little pressure and two leading edge lines have the same pressure from being attached at the middle of the bar...then how does
the kite turn? (I really hope this isn't a dumb question) |