Lanbro - 13-1-2009 at 07:07 AM
Can you use any 4 line bar with the PL Venom2
tridude - 13-1-2009 at 07:18 AM
sure can.......checkout the link for tolerances/safety points/releases...............I fly a 13m Venom on a 55cm modified best bar. Line lengths
should be 27m minimum.............. Im using 28m Q powerlines
http://myweb.tiscali.co.uk/mx5alan/arcs/ARCsetup_FAQ.htm
PHREERIDER - 13-1-2009 at 07:24 AM
any foruline depower bar with a good amount of throw in the bar. 18''-22" at least and a safety line slide ring, i like the main line but with
loops it is annoying if i forget to go back ,,
equal line finish, trim all the way out; bar all the way in ...and you are set
Lanbro - 13-1-2009 at 08:57 AM
So equal line lengths with the bar all the way in is proper tuning? I am probably going to use my Gaastra spinning bar...with the release hooked into
the chicken loop..love that old bar
Lanbro - 13-1-2009 at 08:59 AM
does the venom2 prefer to fly with a little slack in the back lines or none at all...just want to fine tune it..thanks
PHREERIDER - 13-1-2009 at 09:42 AM
the kite will fly front lines ,
yes slack should be present for full range of depower
and the trim all the way out , it is the safest way to set up the bar (not launch)
trim all the way in for unhooked ...if the stall remains then a shorter main may be needed